(set (match_dup 0) (xor:SI (match_dup 0) (const_int 1)))])
;; Use negc to store the T bit in a MSB of a reg in the following way:
-;; T = 1: 0x80000000 -> reg
-;; T = 0: 0x7FFFFFFF -> reg
+;; T = 0: 0x80000000 -> reg
+;; T = 1: 0x7FFFFFFF -> reg
;; This works because 0 - 0x80000000 = 0x80000000.
;;
;; This insn must not match again after it has been split into the constant
"negc %1,%0"
[(set_attr "type" "arith")])
-;; These are essentially the same as above, but with the inverted T bit.
-;; Combine recognizes the split patterns, but does not take them sometimes
-;; if the T_REG clobber is specified. Instead it tries to split out the
-;; T bit negation. Since these splits are supposed to be taken only by
-;; combine, it will see the T_REG clobber of the *mov_t_msb_neg insn, so this
-;; should be fine.
-(define_split
+(define_insn_and_split "*mov_t_msb_neg"
[(set (match_operand:SI 0 "arith_reg_dest")
(plus:SI (match_operand 1 "negt_reg_operand")
- (const_int 2147483647)))] ;; 0x7fffffff
- "TARGET_SH1 && can_create_pseudo_p ()"
+ (const_int 2147483647))) ;; 0x7fffffff
+ (clobber (reg:SI T_REG))]
+ "TARGET_SH1"
+ "#"
+ "&& can_create_pseudo_p ()"
[(parallel [(set (match_dup 0)
(minus:SI (const_int -2147483648) (reg:SI T_REG)))
(clobber (reg:SI T_REG))])])
-(define_split
+(define_insn_and_split "*mov_t_msb_neg"
[(set (match_operand:SI 0 "arith_reg_dest")
(if_then_else:SI (match_operand 1 "t_reg_operand")
(const_int 2147483647) ;; 0x7fffffff
- (const_int -2147483648)))] ;; 0x80000000
- "TARGET_SH1 && can_create_pseudo_p ()"
+ (const_int -2147483648))) ;; 0x80000000
+ (clobber (reg:SI T_REG))]
+ "TARGET_SH1"
+ "#"
+ "&& can_create_pseudo_p ()"
[(parallel [(set (match_dup 0)
(minus:SI (const_int -2147483648) (reg:SI T_REG)))
(clobber (reg:SI T_REG))])])