From: Yann E. MORIN Date: Sun, 8 Mar 2015 15:22:53 +0000 (+0100) Subject: boards/raspberrypi: update readme with RPi-2 specifics X-Git-Url: https://git.libre-soc.org/?a=commitdiff_plain;h=97aaf8b7a27afc87b2fa62197869c3790325147b;p=buildroot.git boards/raspberrypi: update readme with RPi-2 specifics The RPi-2 has its own DTB, so document it in the list of generated files. Also, not all DTBs need to be present on the boot partition, so add a comment that identifies which should be copied for each model. Signed-off-by: "Yann E. MORIN" Cc: Thomas Petazzoni Signed-off-by: Thomas Petazzoni --- diff --git a/board/raspberrypi/readme.txt b/board/raspberrypi/readme.txt index 9bab374b67..b513ca3213 100644 --- a/board/raspberrypi/readme.txt +++ b/board/raspberrypi/readme.txt @@ -62,8 +62,9 @@ After building, you should obtain this tree: output/images/ +-- rootfs.tar [0] +-- rpi-firmware/ - | +-- bcm2708-rpi-b.dtb [1] - | +-- bcm2708-rpi-b-plus.dtb [1] + | +-- bcm2708-rpi-b.dtb + | +-- bcm2708-rpi-b-plus.dtb + | +-- bcm2709-rpi-2-b.dtb | +-- bootcode.bin | +-- config.txt | +-- fixup.dat @@ -73,10 +74,6 @@ After building, you should obtain this tree: [0] Note for Volatile: rootfs.tar will only be there if you kept "tar the root filesystem" option selected in "Filesystem images". -[1] The DTBs (Device Tree Blobs) will only be present if you setup - Buildroot to install the DTBs from the rpi-firmware package, and - will only be used if your kernel has support for the Device Tree. - Prepare you SDCard ================== @@ -104,15 +101,18 @@ Install the binaries to the SDCard At the root of the boot partition, the Raspberry Pi must find the following files: - * bcm2708-rpi-b.dtb [2] + * bcm2708-rpi-b.dtb [1] * bcm2708-rpi-b-plus.dtb [2] + * bcm2709-rpi-2-b.dtb [3] * bootcode.bin * config.txt * fixup.dat * start.elf * zImage -[2] Only needed if your kernel has support for the Device Tree. +[1] For models A and B +[2] For models A+ and B+ +[3] For model 2 For example: