From: John Gilmore <gnu@cygnus>
Date: Sat, 20 Jun 1992 23:32:18 +0000 (+0000)
Subject: * gdb.texinfo:  document `set remotedebug' and `set rstack_high_address'.
X-Git-Url: https://git.libre-soc.org/?a=commitdiff_plain;h=d8a68b284492fdcc23ba412b03f00032e174413a;p=binutils-gdb.git

* gdb.texinfo:  document `set remotedebug' and `set rstack_high_address'.
---

diff --git a/gdb/doc/ChangeLog b/gdb/doc/ChangeLog
index 5917ddc3261..89180f4e159 100644
--- a/gdb/doc/ChangeLog
+++ b/gdb/doc/ChangeLog
@@ -1,3 +1,8 @@
+Sat Jun 20 16:31:10 1992  John Gilmore  (gnu at cygnus.com)
+
+	* gdb.texinfo:  document `set remotedebug' and `set
+	rstack_high_address'.
+
 Thu May 14 17:09:48 1992  Roland H. Pesch  (pesch@fowanton.cygnus.com)
 
 	* gdb.texinfo: slight expansion of new text on reading info files
diff --git a/gdb/doc/gdb.texinfo b/gdb/doc/gdb.texinfo
index 9a3394031b6..3e8b55a2509 100644
--- a/gdb/doc/gdb.texinfo
+++ b/gdb/doc/gdb.texinfo
@@ -4321,6 +4321,24 @@ code generated by your compiler.  If some registers are not saved, or if
 _GDBN__ is unable to locate the saved registers, the selected stack
 frame will make no difference.
 
+_if__(_AMD29K__)
+@item set rstack_high_address @var{address}
+@kindex set rstack_high_address
+@cindex AMD 29K
+On AMD 29000 family processors, registers are saved in a separate ``register
+stack''.  There is no way for GDB to determine the extent of this stack.
+Normally, GDB just assumes that the stack is ``large enough''.
+This may result in GDB referencing memory locations that don't
+exist, you can specify the ending address of the register stack with the
+@code{set rstack_high_address} command.  The argument should be an address,
+which you will probably want to precede with 0x and specify in hexadecimal.
+
+@item show rstack_high_address
+@kindex show rstack_high_address
+@cindex AMD 29K
+Display the current limit of the register stack.
+_fi__(_AMD29K__)
+
 @node Floating Point Hardware,  , Registers, Data
 @section Floating Point Hardware
 @cindex floating point
@@ -6421,6 +6439,14 @@ step and continue the remote program.
 To resume the remote program and stop debugging it, use the @code{detach}
 command.
 
+@kindex set remotedebug
+@kindex show remotedebug
+If you have trouble with the serial connection, you can use the
+command @code{set remotedebug}.  This causes all packets sent back
+and forth across the serial line to be reported to GDB's standard output.
+@code{set remotedebug off} turns it off, and @code{show remotedebug} will
+show you its current state.
+
 Other remote targets may be available in your
 configuration of GDB; use @code{help targets} to list them.