From 6fdb36b84afd785dc6b635a7882c7f6c6b05ba90 Mon Sep 17 00:00:00 2001 From: Gabriel Somlo Date: Mon, 6 Jul 2020 17:00:24 -0400 Subject: [PATCH] liblitesdcard/sdcard: adjust card-ready timeout Testing on nexys4ddr and rocket, approximately 12 iterations of the timeout loop (using `busy_wait(1)`) are needed to receive a "ready" response from the SDcard, assuming a "warm" reset where the card has already been previously initialized. If the SDcard is ejected and re-inserted, or if the board is "cold-reset" (e.g., reprogrammed via openocd vs. a simple push of the reset button), it takes approximately 450 iterations before the SDCard responds with a "ready" message. In either case, a timeout of 10 is insufficient. This patch increases the busy-wait to 10, and the timeout loop counter to 128, which should cover most cases. Additionally, make a few minor cosmetic improvements. Signed-off-by: Gabriel Somlo --- litex/soc/software/liblitesdcard/sdcard.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-) diff --git a/litex/soc/software/liblitesdcard/sdcard.c b/litex/soc/software/liblitesdcard/sdcard.c index 440c8f61..4f0d401e 100644 --- a/litex/soc/software/liblitesdcard/sdcard.c +++ b/litex/soc/software/liblitesdcard/sdcard.c @@ -448,7 +448,7 @@ void sdcard_decode_csd(void) { int sdcard_init(void) { unsigned short rca; - uint16_t timeout; + uint16_t timeout; /* initialize freq */ sdcard_set_clk_freq(16000000); @@ -462,15 +462,13 @@ int sdcard_init(void) { busy_wait(1); sdcard_send_ext_csd(); /* wait for card to be ready */ - timeout = 10; - while (timeout) { + for (timeout = 128; timeout > 0; timeout--) { sdcard_app_cmd(0); sdcard_app_send_op_cond(1, 0); if (sdcard_response[3] & 0x80000000) { break; } - busy_wait(1); - timeout--; + busy_wait(10); } if (timeout == 0) return 0; -- 2.30.2